Wacker Neuson CRT 48-31V Instrukcja Operatora Pobierz pdf (Strona 33)

CRT 48 Maintenance

wc_tx000642gb.fm 33

5.3 Control Linkage Lubrication

The drive system, gearbox and pitch posts are equipped with several

grease fittings. Grease these fittings once a week, or every 20 hours,

to prevent wear.

Use a general purpose grease and add one to two shots of grease at

each fitting.

5.4 Control Arm Adjustment (Forward or Backward)

See Graphic: wc_gr003773

The control arms should line up evenly. If arms appear out of

adjustment, they can be re-adjusted forward or backward as follows:

5.4.1 Loosen jam nuts (b).

5.4.2 Turn the vertical linkage (a) as follows:

• Extend the linkage to adjust control levers forward. See section

4.5 before extending linkage.

• Shorten the linkage to adjust control levers backward.

5.4.3 After the arms have been adjusted to the desired position, tighten jam

nuts (b).

NOTICE: Control arms are adjusted as part of the steering assist

system. Changing orientation of the control arms may affect steering

effort.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 75 76

Brak uwag

Wacker Neuson CRT 48-31V Instrukcja Operatora Strona 33